Configure R.C.P. Communication

You can connect the W.M.D. to the camera via R.C.P. to allow the camera to configure and control the W.M.D. Some of the features included sharing lens metadata, motor configuration, lens profiles management, and wireless settings. To set up R.C.P. communication, follow the instructions below:

1. Connect the RED Start/Stop Cable to the EXP port on the W.M.D.

2. Connect the opposite end to the CTRL port on the camera.

3. Go to Options > EXP Port > R.C.P. in the W.M.D. main menu.

4. A red ‘R’ icon displays on the W.M.D. when the EXP port is configured for R.C.P. communication.

5. Go to Settings > Setup > Communication > Serial in the camera menu.

6. Select R.C.P. Command Protocol from the Ctrl Protocol drop-down menu.

   The W.M.D. displays an indication that the R.C.P. is active.

NOTE: All configuration is now managed from the camera menu under Settings > Motor Control.