DSMC Side Handle: Install/Remove
Install the DSMC Side Handle
WARNING: Before installing or removing this item, you MUST turn off the camera.
REQUIRED TOOL(S): T10 TORX® driver
- Turn off the camera.
- Use a T10 TORX driver to remove the single screw located at the bottom of the BRAIN side plate (if the side plate is installed).
- Rotate the BRAIN side plate upwards to disengage the lip at the top of the side plate from the camera, and remove the BRAIN side plate.
- Insert the lip on the DSMC Side Handle into the slot where the lip of the BRAIN side plate was installed.
- Press the DSMC Side Handle down flush along the side of the camera.
- Rotate the thumbscrew upward while applying steady pressure until tight.
Remove the DSMC Side Handle
WARNING: Before installing or removing this item, you MUST turn off the camera.
REQUIRED TOOL(S): T10 TORX driver
- Turn off the camera.
- Rotate the thumbscrew downward until the DSMC Side Handle detaches from the camera body.
- Disengage the tension lip on the DSMC Side Handle by pulling the bottom away from the camera.
- Insert the tension lip on the BRAIN side plate into the recess on the side of the camera.
- Install the appropriate screw at the bottom of the BRAIN side plate using a T10 TORX driver. DO NOT exceed 70 in-oz, or damage may occur.
- EPIC side plate screw: M3x0.5 x 8 mm
- SCARLET side plate screw: M3x0.5 x 5.5 mm
WARNING: DO NOT OVERTIGHTEN.