REDCODE Burst

NOTE: This mode is not available in Stills mode.

NOTE: Audio is not recorded in REDCODE Burst mode.

In REDCODE Burst mode, the camera can record at a lower compression (REDCODE) for the specified amount of frames. When REDCODE Burst mode is enabled and recording starts, the camera captures a “burst” of frames at the lower REDCODE, and then continues to record at the next available REDCODE. To add more bursts to clips during recording, press any key mapped to “Record: Mark Frame”.

To use REDCODE Burst mode, follow the instructions below:

  1. Go to Menu > Settings > Recording > Mode.
  2. Select REDCODE Burst from the Mode drop-down menu.
  3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
  4. Select a Pre Count and Post Count. For more information, go to Pre Count and Post Count.
  5. Close the menu.
  6. Start recording.

    REDCODE Burst

    Figure: REDCODE Burst